What is the P2015 fault number? What is the description of Intake Manifold Control Position Sensor / Switch Circuit Range/ Performance (Bank 1)? How can I fix P2015 fault code What are the causes and symptoms of the P2015 error code?
What is the P2015 fault code? What does it all mean?
Proper engine operation requires adequate air intake. This is possible because many engine components work together. In some vehicles, the intake manifold control position sensor is one of these components.
It is important to understand the intake manifold flow controller (IMRC) system in order to better understand the code. An intake manifold is an accessory to your vehicle’s motor. The intake manifold provides fresh air intake to the cylinders. The IMRC system is used by many modern vehicles to fine tune the engine’s air intake. This system controls the opening and closing valves, changing the length of manifold distributor components. These valves can be controlled by either an electronic actuator or a vacuum solenoid. The signal from the intake manifold flow sensor position sensor is used by the PCM to determine the operation of IMRC. This sensor is also used to verify that the IMRC valves remain in the right position.
If the powertrain control module PCM/ECM detects that the voltage signal for the intake manifold flow controller position sensor voltage is not within the range, a code P2015 will be triggered. “Bank 1” refers to the engine side with cylinder #1. It may be an electrical or mechanical circuit problem depending on the vehicle manufacturer. The steps for troubleshooting may vary depending on the manufacturer, fuel system, and type of sensor.
Some vehicles, like the Volkswagen GTI and Passat, Audi, Ford and Mercedes, as well as Toyota, Mercedes and Dodge, Nissan, Infiniti and Infiniti models, are more vulnerable to the P2015 fault codes than others.
This code is identical to P2005,P2006,P2007,P2008,P2009,P2010, and P2013.
What is the cause of P2015 Fault code?
- – Defective intake Manifold flow control sensor
- – Defective IMRC actuator / solenoid
- – Circuit problems, such as loose connections or damaged wiring
- – Throttle plate jamming
- – PCM-related issues (rarely).
What are the symptoms of the P2015 Fault Code?
- – Illumination at the check engine lights
- – Increased fuel use
- – Low engine performance (eg, idling fluctuations or lack of power during acceleration).
- – Engine misfires (rarely)
How to Fix the P2015 Fault Code
- – Replacing flow control position sensor for intake manifold
- – Repair or replacement wiring harness
- – Repair any electrical connection problems
- – Return the intake distributor to its correct position
- – Clean the throttle plate
How Serious Is the P2015 Fault Code
Although a P2015 fault code doesn’t prevent the vehicle being driven to safety, fixing it quickly will reduce engine failures.
